Hot Water Heating System Fuel Economizer

i-con  is a microprocessor-based, fuel-saving control for hot water (hydronic) heating systems. i-con 3250 reduces fuel consumption, wear on parts, flue emissions and electrical usage, when installed on any new or existing gas or oil burner. i-con 3250 uses intelligent Dynamic Cycle Management (DCM) technology to save energy by adjusting the burner run pattern to match the system’s “heat load.” Its action is similar to the industry-accepted method of “outdoor- air temperature reset control,” but does not require an outdoor-air temperature sensor or the need to profile the building in order to adjust the “reset” controller properly. i-con 3250 determines the “heat load” by using an easily installed strap-on temperature sensor that monitors the boiler’s out-flow water temperature and the rate that this temperature is changing. 

Features

• For systems up to 400,000 BTU
• Dynamic Cycle Management
(DCM) technology reduces fuel consumption—typically 10% to 20%
• Illuminated LCD display shows fuel consumption savings, operating modes, system diagnostics and operating temperatures
• Short payback period—typically 12
to 24 months

• UL listed, “Energy Management Equipment”
• Increased savings without
replacing or upgrading costly
system components
• “State-of-the-art” microprocessor-based control
• Easily installed plug-in sensor(s)
(includes 1 required sensor)

• Simple installation by qualified
installer

• After commissioning, no follow-up visits are required
• Maximum efficiency year-round
• Reduces maintenance and
extends boiler life
• Fail-safe operation
• Guaranteed to reduce fuel
consumption
• 10-year replacement warranty for breakdowns or defects